Safe And Uncomplicated Ways To Fix A Clogged Toilet

Safe And Uncomplicated Ways To Fix A Clogged Toilet

Blog Article

If your garbage disposal is beginning to act up, or has completely stopped working, there are some simple steps which you can take to identify and fix the problem before calling in an expensive plumber, or replacing the unit. Many times the unit is simply jammed, or has some other fixable problem.

4) You will need to have on hand bathtub replace tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.

The wax ring is used to seal the drain outlet on the bottom of the toilet to the drain opening in the floor. When a toilet is installed, the ring is placed onto the drain... the toilet is dropped onto the ring... and the toilet bolts (also known as closet bolts) are tightened enough to lock the toilet in place. If that wax gasket ring starts to fail or isn't seated properly? Sewer gasses can sneak out from under your toilet causing your bathroom to have that suspicious smell. It can also cause water line repair to escape, sometimes invisibly, with each flush potentially damaging the floor hidden under the toilet.



If you bought the same unit it should line right up, if you were unable, you will need to remove or add length to the existing piping. This may require you to splice together copper with plastic, don't let this scare you the hardware store will have all of the necessary parts.

Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.

The water line repair most likely damaged your electrical outlets and lighting fixtures. Have a qualified electrician come in to evaluate and repair the electrical.

The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.

Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.